A Juntor machining study

We have made a Juntor machining study, because we are going to manufacture a watch case in house. So far, we sent our watch files to Córdoba in Spain. Now, we will make our watches here in Alcoy, almost all parts.

Therefore, we have made this simulation with 360 Fusion software of autodesk. The software allows to know which tools we need to mechanize, feeds, step over, time etc.

In this case we have checked a simulation with titanium material. We have needed 16 minutes for do it with low speed and flood. The finishing has been made until 0,1mm but we can reach 0,05 of precision.

We can mechanize watches in few time. So, we have needed 3 tools and 4 different operations.

Submit a Comment

Your email address will not be published. Required fields are marked *